Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Threaded connection for securing drive shaft to wheel hub | Item.2: M24 x 1.5 thread (always replace screws and lock nuts after removal); grease friction surface of the nut with aluminum paste (do not grease the thread!) | Tightening torque | 460 (340 ftlb.) Nm | ||
| Wheel bearing to wheel carrier | M12 x 1.25 thread (always use new screws and lock nuts following removal) | Initial tightening | 80 (59 ftlb.) Nm | ||
| Wheel bearing to wheel carrier | M12 x 1.25 thread (always use new screws and lock nuts following removal) | Final tightening | + 120° |