Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Pressing out drive shaft | -Max.- | Length | 10 mm | + 5 mm | |
| Threaded connection securing drive shaft to front-axle transmission flange | Item 1: M10 thread | Initial tightening | 50 (37 ftlb.) Nm | ||
| Threaded connection securing drive shaft to front-axle transmission flange | Item 1: M10 thread | Final tightening | + 90° | ||
| Threaded connection securing drive shaft to front-axle transmission flange | Item 1: M8 thread | Initial tightening | 20 (15 ftlb.) Nm | ||
| Threaded connection securing drive shaft to front-axle transmission flange | Item 1: M8 thread | Final tightening | + 90° | ||
| Threaded connection for securing drive shaft to wheel hub | Item.2: M24 x 1.5 thread (always replace screws and lock nuts after removal); grease friction surface of the nut with aluminum paste (do not grease the thread!) | Tightening torque | 460 (340 ftlb.) Nm |