Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Threaded connection securing trailing arm to spring strut | Item 1: M14 x 1.5 thread (always use new screws and lock nuts following removal) | Initial tightening | 150 (111 ftlb.) Nm | ||
| Threaded connection securing trailing arm to spring strut | Item 1: M14 x 1.5 thread (always use new screws and lock nuts following removal) | Final tightening | + 90° | ||
| Threaded connection securing lower trailing arm to chassis subframe | Item 4: M14 x 1.5 thread | Tightening torque | 170 (126 ftlb.) Nm | ||
| Threaded connection securing lower trailing arm to pivot bearing | Item 7: M14 x 1.5 thread (always use new screws and lock nuts following removal) | Tightening torque | 130 (96 ftlb.) Nm |