Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc. |
|---|---|---|---|---|---|
| Threaded connection securing upper trailing arm to body | Item 2: M10 x 70 thread (always use new screws and lock nuts following removal) | Initial tightening | 50 (37 ftlb.) Nm | ||
| Threaded connection securing upper trailing arm to body | Item 2: M10 x 70 thread (always use new screws and lock nuts following removal) | Final tightening | + 180° | ||
| Installation dimension for upper axle bearing | Length | 118.5 mm | +/- 6 mm |