Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Turbocharger oil feed line to cylinder head | M14 x 1.5 (2 ea.) | Tightening torque | 35 (26 ftlb.) Nm | ||
| Holding clamp on vent line to collection pipe | M6 (2 ea.) | Tightening torque | 6.5 (5 ftlb.) Nm | ||
| Turbocharger oil feed line holder to lower part of crankcase | M6 x 12 (1 ea.) | Tightening torque | 10 (7.5 ftlb.) Nm | ||
| Holding clamp for oil feed line to holder | M6 x 12 (1 ea.) | Tightening torque | 10 (7.5 ftlb.) Nm | ||
| Oil extraction line to turbocharger | M6 x 16 (4 ea.) | Tightening torque | 10 (7.5 ftlb.) Nm |