Replacing Charge Air Cooler
WARNING: This page is about a different variant/trim than selected.
- Remove accessories.
- 1.1 Unscrew fastening screws -1-
for the charge air line -2-
at the charge air cooler -3-
.
Charge air line on charge air cooler
- 1.2 At the rear air guide -1-
, unclip the side locking mechanisms -2-
and pull out the air guide.
Removing rear trim panel on charge air cooler
- 1.3 At the front air guide -2- , unclip the side locking mechanisms -1- and pull out the air guide.
Removing front trim panel on charge air cooler
- 1.1 Unscrew fastening screws -1-
for the charge air line -2-
at the charge air cooler -3-
.
- The accessories are installed in reverse order to removal.
- 2.1 Tighten fastening screws for the intake pipe to > Tightening torque 5.5 Nm .