Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Close the fuel tank. To do this, fit the sheet-metal ring on the left and right connection unit and tighten using special tool > T10202 - wrench. > Cap > Tightening torque 145 (107 ftlb.) Nm +/- 5 (3.5 ftlb.) Nm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cap
Fit all connections of the right connection unit (fuel lines, ventilation lines and electric connectors). > Fuel supply and connection points at right connection unit

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fuel supply and connection points at right connection unit
Plug in electric plug connection for the left connection unit.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Connector for left connection unit
Fit the left cap (figure shows both caps). Then tighten the four fastening nuts to > Tightening torque 10 Nm .
Refit loosened carpeting and fix with double-sided adhesive tape.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening nuts for cap
Install rear seat.
> Refer to the appropriate service information
Fill the fuel tank.
> 200317 Draining and filling fuel - section on "FILLING "
Close the filler flap.
Connect the battery.
> 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY