Installing Fuel Supply Line

Information 

• The description applies to all engine types.
• The setup and procedures required may differ slightly from the illustrations or procedures described due to engine-specific differences.

1. The fuel supply line is installed in reverse order to removal.
2. Tighten fastening screws on restraining straps to > Tightening torque 23 (17 ftlb.) Nm  .
3. Tighten three M6 collar nuts to > Tightening torque 10 (7.5 ftlb.) Nm  and one M6 fastening screw to > Tightening torque 10 (7.5 ftlb.) Nm  .
4. Tighten two fastening screws for the heat shield on the cardan shaft to > Tightening torque 10 (7.5 ftlb.) Nm  and one collar nut for the heat shield on the cardan shaft to > Tightening torque 20 (15 ftlb.) Nm  .