Removing Control Unit For Distance Measuring Sensor

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position (show on the Panamera)

1. Switch off ignition and remove the remote control from the ignition lock.
2. Remove cover on sensor.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing cover on sensor

   1. 2.1  Release cover twice at the top -arrow-  .
   2. 2.2  Fold cover forwards and detach at the bottom holder.
3. Release two electric plug connections -a-  and disconnect connector from control unit for distance measuring sensor.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Disconnecting plug connection

4. Unscew the two fastening screws -1-  from holder for control unit for distance measuring sensor.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Unscrewing fastening screws (shown on the Panamera)

5. Twist holder together with control unit for distance measuring sensor, release cable clip -2-  and remove the electric line.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Open cable clip and remove line (shown on the Panamera)

6. Remove holder together with control unit for distance measuring sensor.