LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Cayenne S >> Repair and Diagnosis >> Engine Mechanical >> Starter >> 27 - Starter, Power Supply, Cruise Control (4.8L Non Turbo) -- 92A - Cayenne (92A) >> WM, 278519 Removing And Installing Control Unit For Distance Measuring Sensor >> Installing Control Unit For Distance Measuring Sensor

Installing Control Unit For Distance Measuring Sensor

  1. Position holder with the distance measuring sensor control unit.
  2. Place electric line into cable clip -2-  and clip together.
    G16310819Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Securing electric line with cable clip (shown on the Panamera)

  3. Position holder on the bumper and secure using the two fastening screws -1-  .
    G16310820Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Securing holder

  4. Press in electric connector until it clicks into place.

    Information 

    Before and after fitting the trim cover for the distance measuring sensor control unit, check the following points:

    • The holder for the distance measuring sensor control unit must not show any signs of deformation, which may have been caused, for example, by removing or installing the trim c over for the distance measuring sensor control unit. If the holder for the distance measuring sensor control unit is deformed carefully push it back into shape. 
    • If the trim cover is damaged or cracked, replace the trim cover. 
    • After fitting the trim cover, check that it is seated correctly and securely. 
  5. Fit cover for distance measuring sensor.
    G16310821Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fitting ACC sensor cover (shown on the Panamera)

scientia non olet · About LEMON Manuals