Removing And Installing Battery Cover
WARNING:
Caustic fluids
- Danger of chemical burns
→ Wear personal protective gear.
→ Ensure that there is good ventilation.
→ Avoid contact with caustic fluid.
→ if you do come into contact, wash off immediately with plenty of warm water and contact a doctor if necessary.
WARNING:
Static battery charge
- Battery can explode
- Electrical discharges
→ Do not rub the battery with a dry cloth.
Information
- The battery is located in the battery box under the left front seat.
- The vehicle must be supplied with external power at the jump-lead starting points so that the seat can be moved even when the battery is fully discharged.
> 2706IN GENERAL INFORMATION ON AGM VEHICLE BATTERY
Installation position of battery
Information
Switch off all loads and remove the ignition key.
- Do not disconnect the battery while the engine is running.
- Disconnect and re-connect battery with extreme caution.
- When removing the carpeted floor for the first time, cut along the perforation using a carpet knife.
- Unscrew screw -1-
and remove air guide -2-
.
Removing battery cover
- Ope i the tension hooks -arrows- on the battery cover -3- using a suitable tool.
- Remove battery cover -3- .
- The battery cover -3- is installed in reverse order to removal.
- Tighten screw -1- . > Tightening torque 2 (1.5 ftlb.) Nm .