LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Cayenne S >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> 19 - Engine - Cooling (4.8L Non Turbo) -- 92A - Cayenne (92A) >> WM, 19201901 Removing And Installing Cooling Fan Housing (Radiator Frame) >> Removing Cooling Fan Housing (Radiator Frame) >> Removing Cooling Fan Housing (Radiator Frame) On Naturally Aspirated Vehicles

Removing Cooling Fan Housing (Radiator Frame) On Naturally Aspirated Vehicles

WARNING: Electrically moved components 
  • Danger of limbs being trapped or severed 

    → Switch off electric power to drive motor.

    → Make sure it does not switch on again.

    → Check that there is no electric charge.

  1. Unclip electric lines from the brackets.
  2. Release and disconnect electric plug connection -6-  for fan on the cooling fan housing -a-  .
    G16308743Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pulling off connector on cooling fan housing

    3 Release and disconnect electric plug connection -8- at the cooling water hose. 

    G16308744Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pulling off connector on cooling water hose

  3. Release locking springs -9-  at the left and right of the cooling fan housing.
    G16308745Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Releasing locking springs

  4. Carefully press cooling water hose -10-  to one side.
    G16308746Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pressing cooling water hose aside

  5. Pull cooling fan housing out of the brackets at the side and at the bottom and swivel it to the right slightly (in direction of travel) -arrow A-  .
    G16308747Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pulling out cooling fan housing

  6. Carefully remove the cooling fan housing by pulling it up -arrow B-  .
scientia non olet · About LEMON Manuals