Removing Boost Pressure Sensor

Disconnect electric plug connection -arrow- on the boost pressure sensor.

Fig 1: Identifying Boost Pressure Sensor Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove screws. Pull boost pressure sensor out of the adapter.

Cylinder bank 2 (left):
1. 1.1. Expose vacuum hose -1- .
2. 1.2. Unscrew screws -arrows- and remove cover -2- .
  
  Fig 1: Exposing Boost Pressure Sensor For Cylinder Bank 2
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Continue as follows for both sides:
1. 2.1. Disconnect electric plug connection -1- .
  NOTE:
  Dirt on injection system components
  - Material damage
  - Rough-running engine
  - Bad exhaust emissions
  → Thoroughly clean connection points and adjacent areas before loosening them. If the engine is very dirty, wash it before starting disassembly work.
  
  → Lay removed parts on a clean surface and cover them. Do not use fibre-shedding cloths.
  
  → Carefully cover components or seal them if repair work will not be carried out immediately. Place rubber caps on connections. Seal intake openings with film or adhesive tape.
  
  → Only install clean parts. Do not take spare parts out of the packaging until just before installation.
  
  → Never use compressed air when the system is open. Do not move the vehicle.
2. 2.2. Unscrew screws -arrows- and remove boost pressure sensor.
  
  Fig 2: Removing Boost Pressure Sensor
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.