LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Cayenne Base, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 21 - Exhaust Gas Turbocharging -- 92A Cayenne >> WM 219019 Removing And Installing Boost Pressure Sensor [Cayenne S E-Hybrid & Cayenne (3.0)] >> Installing Boost Pressure Sensor

Installing Boost Pressure Sensor

Information 

For tightening torques, tightening sequence and assembly overview, see → 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS

Information 

Replace sealing ring.

  1. Installation is performed in reverse order.


Information 

For tightening torques, tightening sequence and assembly overview, see → 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS

  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1. The self-locking screws and O-ring must be replaced.
    2. 1.2. Before installation, remove all residual sealant from the threaded bores for the boost pressure sensor in the compressor housing using a thread cutter.
scientia non olet · About LEMON Manuals