LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Boxster Spyder, Standard Trans >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> 40 - Front Wheel Suspension, Drive Shafts -- 987-BOXSTER-CAYMAN >> WM 405055 Replacing Front Wheel Bearing Housing (All Models) >> Completing (Disassembling And Assembling) Wheel Bearing Housing

Completing (Disassembling And Assembling) Wheel Bearing Housing

  1. Disassemble old wheel bearing housing and fit reusable parts to the new wheel bearing housing (speed sensor, brake cover plate, lid for wheel bearing -3-  , fastening screws -2-  , wheel hub -1-  and tension bolt).

    The wheel bearing -4-  must be replaced.

    1. 1.1. Take off brake cover plate on the wheel bearing housing. Press wheel hub -1-  out of the wheel bearing housing (wheel bearing) → Removing Front Wheel Bearing 
    2. 1.2. Remove lid -3-  for wheel bearing on the wheel bearing housing (4 screws).
    3. 1.3. Press new wheel bearing -4-  into the new (heated) wheel bearing housing and complete the wheel bearing housing → Installing Front Wheel Bearing  .
    2. Fig 1: Identifying Wheel Bearing Housing Components
    G09587501Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals