LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Boxster Spyder, Standard Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> 46 - Brakes - Brake Mechanics -- 987-BOXSTER-CAYMAN >> WM 463819 Removing And Installing Rear Disc Brake Pads (Except CAYMAN Black Edition, CAYMAN S Black Edition, BOXSTER Black Edition, BOXSTER S Black Edition, CAYMAN R) >> Removing Rear Disc Brake Pads

Removing Rear Disc Brake Pads

  1. Remove the safety bracket and extract the retainer pin inwards -arrows-  .
    Fig 1: Removing Rear Disc Brake Pads
    G09587815Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Pull out the warning contact wire on the brake calliper and remove the warning contacts from the brake pad plates.

    Contrary to the illustration, there are no vibration balancers on the brake pads.

  3. Remove brake pads using the brake pad puller. Always observe the following important points:

Press the brake pads back as far as possible using the piston resetting fixture.

Pull out the brake pads together with the brake-piston damping plates (if present/Boxster S only). If this is not possible (depending on the amount of wear on the brake pads), use a spatula to detach the vibration dampers from the brake pad backing plate.

scientia non olet · About LEMON Manuals