Installing Brake Cables

1. 1.1. Insert brake cables (at the underbody) into the housing or into the guide tubes (as of 2009 model) and press them in as far as they will go.
2. 1.2. Insert brake cables -1-  into the guide tubes -5-  at the wheel bearing housing and press them in as far as they will go -arrow-  .
   Fig 1: Installing Brake Cables

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. 2.1. Fit expanding-lock -8-  at the brake cable -1-  and press the bolt -7-  into the bore.
2. 2.2. Fit circlip -6-  on the bolt -7-  .

Fig 2: Identifying Brake Cables At Expanding-Lock

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Turn the lever -3-  and engage brake cables -1-  .

Fig 3: Identifying Brake Cables And Handbrake Lever

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. 4.1. Open the lid on the oddments tray.
2. 4.2. Fit center console floor at the rear -2-  and secure with the fastening screws -1-  .

Fig 4: Identifying Centre Console Floor Mounting Bolts

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. 5.1. Fit center console insert at the rear -1-  (-arrow-  ) and close the lid on the oddments tray.

Fig 5: Installing Centre Console Insert

Courtesy of PORSCHE CARS NORTH AMERICA, INC.