| Threaded connection securing brake calliper to front and rear axle, M12 x 1.5 |
Always replace screws on front and rear axle following removal. |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Retaining pin for brake pads for 6-piston brake callipers, M8 |
Always replace screw following removal. |
Tightening torque |
30 Nm (22 ftlb.) |
|
|
| Threaded connection securing brake disc to wheel hub (front and rear axle), M6 |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Threaded connection securing brake cover plate to front and rear axle, M6 |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Threaded connection securing speed sensor to front and rear axle, M6 |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Threaded connection securing brake hose bracket to wheel carrier (front and rear axles), M6 |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Combination plug connection (plug-in coupling) to wheel carrier (front and rear axles), M6 |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Threaded connection securing brake unit to body (aluminum interm. part), M8 |
|
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Threaded connection securing brake unit support to body, M8 |
|
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Threaded connection securing parking brake console to body, M8 |
|
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Threaded connection securing bracket for hydraulic unit to body, M6 |
|
Tightening torque |
4 Nm (3.0 ftlb.) |
|
|
| Threaded connection securing hydraulic unit to holder, M6 |
|
Tightening torque |
5.5 Nm (4.0 ftlb.) |
|
|
| Brake pedal to brake pushrod (M8 x 1 threaded bolt) |
Always replace threaded bolt following removal |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Brake pushrod to brake booster (collar nut M6) |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Brake pushrod to adjusting piece (lock nut) M12 x 1.5 |
|
Tightening torque |
30 Nm (22 ftlb.) |
|
|
| Pedal bearing axle in pedal block |
|
Tightening torque |
8to10 Nm (6 to 7.5 ftlb.) |
|
|
| Locknut pedal bearing axle to pedal block right M8 |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Locknut pedal bearing axle to pedal block left M14 |
|
Tightening torque |
46 Nm (34 ftlb.) |
|
|