Installing Vacuum Pump

Clean contact surfaces on the vacuum pump and left cylinder head.

1. 2.1. Replace sealing rings.

   Grease sealing rings -2, 3-  with "Kluber Syntheso Glep

   1" (Porsche Part No. 000.043.204.68) before fitting them.

   Fig 1: Identifying Vacuum Pump With Sealing Rings

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 2.2. Align vacuum pump driver -1-  .
3. 2.3. Fit vacuum pump and screw in and tighten external Torx screws (M6 x 20) -4-  .

   → Tightening torque: 9 Nm (6.5 ftlb.) 

1. 3.1. Check sealing rings -1-  on vacuum line -2-  and replace if necessary.
   Fig 2: Identifying Sealing Rings On Vacuum Line

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 3.2. Fit vacuum pipe -2-  and screw in and tighten M6 x 12 screws -1- 

   → Tightening torque: 10 Nm (7.5 ftlb.) 

Fig 3: Tightening Screw Vacuum Pipe

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. 4.1. Insert vacuum line and electric line into clip holder -2-  .
2. 4.2. Connect plug-in coupling -1-  at the vacuum line.

   Make sure that the plug-in coupling -1- locks with an audible click. 

Fig 4: Identifying Vacuum Line And Electric Line Into Clip Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.