Installing Front Control Unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

→ Remove the ignition key and switch off load before disconnecting or removing load.

1. Insert the front control unit into the body and secure with the fastening nut -2-  . → M6: 9.7 Nm (7.5 ftlb.) 
   Fig 1: Engaging Control Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Plug in electric connector and lock it so that it engages securely.
3. Clip in left and right electric lines to the control unit.
Fig 2: Plugging Electric Connectors
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Position the cover -1-  and push it in until it snaps into place in the four clips.
5. Secure the cover with the fastening screw -3-  .
6. If a new control unit was installed, it must be coded to suit the vehicle. → Coding (Programming) Control Unit 
Fig 3: Fitting Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.