LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> 94 - Lights, Lamps, Switches, Exterior -- 987-BOXSTER-CAYMAN >> WM 943119 Removing And Installing Tail Light (All Models) >> Installing Tail Light

Installing Tail Light

  1. Examine the tail light seal.

    Information 

    If the tail light is only removed and installed again, the seal for the tail light can be re-used.

    If the seal for the tail light is damaged, this seal must be replaced.

    If the seal is removed from the light, this seal must be replaced.

    • If necessary: Pull off the seal and carefully clean the sealing face with a knife. 
  2. Position the tail light in the mounting in the wing and secure with the three fastening nuts --1-  -.
  3. Push on the central connector on the tail light until the connector clicks into place.
    4. Fig 1: Securing Tail Light
    G09593447Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals