Testing And Adjusting Headlight Mount

Information 

The headlight cover lens should lie approximately 2 mm below the body edge.

Fig 1: Identifying Headlight Cover Lens Edge

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Where the headlight housing joins the body, both should be in the same plane (flush).

Fig 2: Locating Headlight Housing Joins Body Area (1 Of 2)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fig 3: Locating Headlight Housing Joins Body Area (2 Of 2)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adjust fastening nuts to the same height as the old unit and tighten gently by hand.

1. Adjust fastening nuts to the same height as the old unit and tighten gently by hand.
2. Press headlight housing firmly into the body and lock.
3. After adjustment, tighten the fastening nuts. → Tightening torque: 6 ftlb.+/-1.5 ftlb. 
Fig 4: Locating Plate Mounting Bolts
Courtesy of PORSCHE CARS NORTH AMERICA, INC.