Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the 911 Carrera, 2D Convertible, 3.4L Eng, Automatic DCT Trans, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All (Both Axles) | 2.2 | B | ||
| Front,Both | 1.2 | B | ||
| Rear,Both | 1.2 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: Includes: Bleed Brake System. | ||||
| Each Additional | 0.2 | B | ||
| One | 1.1 | B | ||
| Combination Procedure: BRAKE PAD WEAR SENSOR: Replace: | ||||
| Front | 0.1 | B | ||
| Rear | 0.1 | B | ||
| Combination Procedure: CALIPER: Overhaul: Includes: Bleed Brake System. | ||||
| Front & Rear,One | 0.8 | B | ||
| Combination Procedure: CALIPER: Replace: Includes: Bleed Brake System. | ||||
| One | 1.1 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Remove & Install or Remove & Replace: | ||||
| Front,Each | 0.2 | B | ||
| Rear,Each | 0.5 | B | ||
| Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.3 | B | ||
| One | 0.5 | B | ||
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both Sides | 1.4 | B | ||
| One Side | 0.6 | B | ||