Installing Charging Socket

Push wire harness through the rubber sleeve into the luggage compartment and route wire harness loosely.
Plug high-voltage connector -1- and 12-volt connector -2- into the high-voltage charger and lock them.

Fig 1: Identifying Plugging In Connector On High-Voltage Charger
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Route wire harness -1- in the luggage compartment, clip it into the cable duct and secure with tie-wraps.

Fig 2: Securing Wire Harness In Luggage Compartment
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Installation position of the rubber sleeve through the bodyshell must always be observed. The arrow shown on the rubber sleeve must be pointing straight up.
Press rubber sleeve into the wheel housing. Check that it is positioned, fitted and sealed correctly.
Plug in electric plug connection -2- until it engages securely and position and clip in charging tray -1- .

Fig 3: Identifying Charging Tray And Electric Plug Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Plug in electric plug connection on the switch -1- until it engages securely. Clip switch into the charging tray -A- .

Fig 4: Installing Switch For Charging Socket
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position charging socket and tighten fastening nuts -1- to → Tightening torque: 9.7 Nm (7.5 ftlb.) .
1. 7.1. If fitted, plug in electric plug connection at the actuator until it engages securely.
  
  Fig 5: Identifying Charging Socket Fastening Nuts
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten ground strap -1- to → Tightening torque: 9.7 Nm (7.5 ftlb.) .

Fig 6: Identifying Ground Strap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clip wire harness -1- into the wheel housing.

Fig 7: Identifying Wire Harness Clip In Wheel Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.