Technical Values: Notes
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Lid to roof (R1) | Gap dimension | 5 mm | +1 mm | ||
|
Gap dimension |
|||||
| Lid to roof (R6) | Gap dimension | 2 mm | +0.5 mm | -0.5 mm | |
|
Gap dimension |
|||||
| Lid to side panel (R2) | Gap dimension | 4 mm | +1 mm | -0.5 mm | |
|
Gap dimension |
|||||
| Lid to side panel (R3) | Gap dimension | 4 mm | +1 mm | -0.5 mm | |
|
Gap dimension |
|||||
| Lid to rear apron (R4) | Gap dimension | 5 mm | +1 mm | -1 mm | |
|
Gap dimension |
|||||
| Lid to rear apron (R5) | Gap dimension | 3 mm | +1.5 mm | -1.5 mm | |
|
Gap dimension |
|||||
| Fastening screws securing lid hinge to lid | Tightening torque | 23 Nm (17 ftlb.) | |||
| Fastening nuts securing lid hinge to roof | Tightening torque | 23 Nm (17 ftlb.) | |||
| Fastening screws for adjusting element | Tightening torque | 5.5 Nm (4 ftlb.) | |||
| Fastening screws for lower part of lid lock | Tightening torque | 23 Nm (17 ftlb.) | |||