Removing Cutoff Relay

→ Disconnect the battery before removing the component or control unit.

→ Always use new fastening screws and nuts following removal.

→ Observe specified tightening torques.

→ Carry out a visual inspection of all re-used parts.

Fig 1: Identifying Power Distributor Cutoff Relay Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Switch off ignition and remove remote control.
2. Unscrew and remove the fastening screw on the power distributor (HSB) -arrow A-  .
3. Pull the power distributor (HSB) up out of the guide -arrow B-  and carefully set it aside.
   Fig 2: Unscrewing Fastening Screw

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Release the cover on the power distributor (HSB) and open it.
   Fig 3: Opening Cover

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Release electric plug connections for the cutoff relays and disconnect them.
   Fig 4: Disconnecting Electric Plug Connections

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Unclip the (HSB) control unit at the clips -1-  and set it aside together with the connections.
   Fig 5: Unclipping (HSB) Control Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
7. Unscrew fastening nuts on the cutoff relays.
   Fig 6: Unscrewing Fastening Nuts

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
8. Pull the eyelets -2-  of the electric lines up and out.
   Fig 7: Removing Eyelets

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
9. First remove cutoff relay -3-  , then cutoff relay -4-  .
   Fig 8: Removing Cutoff Relay

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.