Technical Values

Location	Description	Type	Basic value
Air spring compressor to chassis subframe	M6 x 16 thread	Tightening torque	10 Nm (7.5 ftlb.)
Pressure line to air spring compressor		Tightening torque	4 Nm (3 ftlb.)
Pressure line to valve block		Tightening torque	4 Nm (3 ftlb.)
Pressure line to pressure accumulator		Tightening torque	5 Nm (3.5 ftlb.)
Pressure line to spring strut		Tightening torque	3 Nm (2 ftlb.)
Valve block to underbody		Tightening torque	4 Nm (3 ftlb.)
Pressure accumulator to body		Tightening torque	4 Nm (3 ftlb.)
Rear self-levelling sensor holder to chassis subframe	M6x16 thread	Tightening torque	8 Nm
Front levelling system holder to body	M6x16 thread	Tightening torque	10 Nm (7.5 ftlb.)
Mount to subframe	M6 x 10 thread	Tightening torque	10 Nm (7.5 ftlb.)
Rubber mounting for expansion hose to chassis subframe	Rubber mounting	Tightening torque	1 Nm (0.5 ftlb.)
Expansion hose to rubber mounting for chassis subframe	M6 x 18 thread	Tightening torque	10 Nm (7.5 ftlb.)
Pressure line to rear-axle anti-roll bar	M14 x 1.5 thread	Tightening torque	28 Nm (21 ftlb.)
Pressure line to rear-axle anti-roll bar	M16 x 1.5 thread	Tightening torque	28 Nm (21 ftlb.)
Pressure line to valve block	M14 x 1.5 thread	Tightening torque	28 Nm (21 ftlb.)
Pressure line to valve block	M16 x 1.5 thread	Tightening torque	28 Nm (21 ftlb.)
Pressure line to valve block	M14 x 1.5 thread	Tightening torque	28 Nm (21 ftlb.)
Return line to valve block	M16 x 1.5 thread	Tightening torque	28 Nm (21 ftlb.)
Clip to rear-axle anti-roll bar	Worm clip	Tightening torque	5 Nm (3.5 ftlb.)
Valve block holder to chassis subframe	M6 x 20 thread	Tightening torque	10 Nm (7.5 ftlb.)
Valve block to holder	M6 x 30 thread	Tightening torque	10 Nm (7.5 ftlb.)
Valve block to chassis subframe	M6 x 30 thread	Tightening torque	10 Nm (7.5 ftlb.)
Reservoir holder		Tightening torque	10 Nm (7.5 ftlb.)