Removing Spreader Device (EPB Actuator)

The spreader device (actuator) is fitted on the rear-axle wheel bearing housing

1. Actuator
2. Tie-wrap - prevents twisting
   Fig 1: Identifying EPB Actuator

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. If the actuator has to be re-used, secure it in the brake shoe mountings with a tie-wrap to prevent it from twisting! -arrow- 
   Fig 2: Locating Servo Motor Lock

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Carefully disconnect electric connector at the actuator and pull it off.
3. Loosen fastening screws -arrows-  on the actuator.
   Fig 3: Locating Actuator Mounting

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Turn the wheel hub so that the actuator can be removed carefully. → Removing actuator 
   Fig 4: Removing Actuator

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.