Installing Frame For Light

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Apply adhesive. → Application depth: 3.0 mm 

   Working with body structural adhesive → 5x00in working with body structural adhesive

   Fig 1: Applying Adhesive

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   Fig 2: Applying Adhesive

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   Fig 3: Applying Adhesive

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Fit frame for light.

   Observe gap dimensions. → 5x00in diagram - body gap dimensions

3. Rivet in frame for light.→ blind rivet 999.190.228.01
   Fig 4: Fitting Frame Light

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   Fig 5: Riveting In Frame Light

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Stick on new insulating mat.
   Fig 6: Identifying Stick On Insulating Mat

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.