| No. 3: Threaded connection securing tie rod to tie-rod end |
M16 x 1.5 thread, lock nut |
Tightening torque |
90 Nm (67 ftlb.) |
|
|
| No. 8: Heat shield to steering gear |
M6 x 16 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| No. 4: Threaded connection securing lower trailing arm to suspension subframe |
M14 x 1.5 thread |
Tightening torque |
170 Nm (126 ftlb.) |
|
|
| No. 8: Threaded connection securing lower trailing arm to chassis subframe (rear) |
M14 x 1.5 thread (always replace screws and lock nuts after removal) |
Tightening torque |
170 Nm (126 ftlb.) |
|
|
| No. 2: Threaded connection securing tie rod to chassis subframe |
M14 x 1.5 thread (always replace screws and lock nuts after removal) |
Tightening torque |
170 Nm (126 ftlb.) |
|
|