Installing Antenna For Tyre Pressure Monitoring (TPM)

Information 

Before installing the antenna, visually check the antenna and plug connection with regard to the following points:

• Damage to the housing.
• Damage to the contacts on the antenna.
• Damage to the connector and contacts on the vehicle wire harness.
• Dirty contacts.

If the antenna is damaged, replace it.

If the wire harness, connector or contacts are damaged, repair them in accordance with the relevant safety instructions using the > Nr.155-2 - Repair kit for wiring harnesses. 

If the contacts are dirty, clean them.

1. The Tire Pressure Monitoring (TPM) antenna is installed in reverse order to removal.
2. Tighten the two plastic fastening nuts.

   > Tightening torque 2 (1.5 ftlb.) Nm