Further To 3: Fitting The Wheel On The Vehicle
WARNING: This page is about a different variant/trim than selected.
Fit the wheel using a suitable commercially available tool
Information
- Never use an impact bolter.
- Observe the description on wheel removal and installation (fitting wheel on vehicle)
- Fit the wheels with the lowest residual imbalance values on the front axle. Observe the rolling direction of the wheels.
.
Screw in wheel bolts by hand and then tighten evenly. Start at the top when tightening. Always observe the specified tightening torque of 160 Nm (118 ftlb.)
Set required tire pressure (tire-pressure plate).