Adjusting Selector Lever Cable

Information 

Position N is marked by an arrow on the selector support.

1. Shift the selector lever to position N.
   NOTE: The fastening screw for the selector lever cable must not be loosened by more than one n. 

   • Otherwise, the screw will fall into the selector support and the selector support will have to be replaced. 
     • The fastening screw for the selector lever cable must not be loosened by more than one turn.
2. Loosen the fastening screw in opening -3-  next to the emergency release -4-  for connecting the selector lever cable -2-  and selector support -1-  by 180° using a 5-mm Allen key, approx. 15 cm long. 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing selector cable

3. Shift the transmission to position N -A-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Shifting transmission to position N

4. Tighten fastening screw in small opening -3-  using 5-mm Allen key, approx. 15 cm long  next to the emergency release -4-  for the selector cable -2-  on the selector support -1-  .

   > Tightening torque 10 (7.5 ftlb.) Nm

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Securing selector cable