Installing Front Bumper

Information 

• Some of the repair illustrations show only one side of the vehicle. 
• Naturally, some steps also have to be performed on the opposite side of the vehicle as well. 

1. Fit the bumper between the lock carrier and longitudinal member from underneath and position it.
2. Installation is performed in reverse order to removal.
3. Tighten fastening screws for the body to Tightening torque 60 Nm (44 ftlb.) +/-5 Nm (+/-3.5 ftlb.)  .
4. Tighten fastening screws on body mounts to Tightening torque 25 Nm (19 ftlb.) +/-2.5 Nm (+/-2 ftlb.)  .
5. Tighten fastening screws on the lock carrier to Tightening torque 12 Nm (9 ftlb.) +/-1 Nm (+/-0.5 ftlb.)  .
6. Tighten fastening screw on the lock support to Tightening torque 9 Nm (6.5 ftlb.) +/-9 Nm (+/-6.5 ftlb.)  .