Installing Rear Brake Disc

Information 

• Replace brake calliper fastening screws each time they are removed  .

Do not confuse left and right brake discs during assembly!

1. Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
2. Clean the flat and centering surfaces on the brake disc and wheel hub.
3. Apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
4. Installation is performed in reverse order.

   Observe specified tightening torques:

   Brake disc to wheel hub: Tightening Torque 15 Nm (11 ft. lb.)

   Brake calliper to wheel bearing housing: Tightening Torque 85 Nm (63 ft. lb.)

   Cable holder to wheel bearing housing: Tightening Torque 8 Nm (6 ft. lb.)

5. Position disc brake pads by operating the brake several times.
6. Check the brake fluid level and correct it if necessary.