Installing Brake Pedal

Information 

• Do not grease or spray the brake pedal shaft (bearing pin)  .
• Use new lock nuts  .
• Observe correct Tightening Torques →  4X - CHASSIS - GENERAL -- 92A CAYENNE  Tightening Torques for brake mechanism - section on "Technical values"  .
• Tightening Torque for brake pedal shaft (bearing pin): 20 ± 3 Nm/15 ± 2 ft. lb.  .

1. Insert brake pedal into the vehicle.
2. Press the brake pedal shaft -1-  fully into the brake pedal -1-  (-arrow-  ).
   Fig 1: Pressing In Brake Pedal Shaft

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. When pushing in the brake pedal shaft -1-  , make sure that the cut-out -2-  on the brake pedal shaft -1-  fits into the guide -3-  on the holder -4-  .
   Fig 2: Identifying Brake Pedal Shaft, Guide And Holder

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Slide the lock -1-  at the left onto the brake pedal shaft -2-  (-arrow-  ).
   Fig 3: Fitting Brake Pedal Lock

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Position brake pedal -1-  on the push rod -2-  for the brake booster.
   Fig 4: Positioning Brake Pedal On Push Rod

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Press brake pedal -1-  fully -arrow-  until the push rod -2-  engages with an audible click in the holder -3-  on the brake pedal.
   Fig 5: Fitting Brake Pedal

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.