Installing Rear Logo Without Model Designation

Information 

• Carefully clean any dirt, grease, wax and other impurities off the installation area of the body using isopropanol. 
• Always use a clean cloth. 
• The room and object temperature must be at least → Nominal value: +15°C  .
• Humidity should be → Nominal value: 50 %+/-10 %  .
• Do not touch the bonding surface again after removing the protective paper. 
• Wear clean gloves during the bonding process in order to guarantee adequate adhesion. 
• The parts must have been bonded for at least → Nominal value: 72 h before washing the vehicle in a car wash. 

1. Logo template - E2 9864 -1-  must be positioned on the vehicle.
   1. 1.1. Position the edges -2, 3-  of the logo template -1-  flush with the rear lid.
   2. 1.2. Press logo template -1-  firmly onto the rear lid.
      Fig 1: Positioning Logo Template

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Remove protective paper from the logo -1-  .
3. Align the logo -1-  at the lower edge -arrow-  in the logo template -2-  and press it on firmly.
   Fig 2: Aligning Logo At Lower Edge

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Remove logo template from the vehicle.