LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> Boxster Spyder, Standard >> Repair and Diagnosis >> Engine Mechanical >> 27 - Starter, Power Supply, Cruise Control -- 987-BOXSTER-CAYMAN >> WM 276019 Removing And Installing Starter (CAYMAN S, CAYMAN S "PORSCHE Design Edition 1", CAYMAN S Sport, BOXSTER S, BOXSTER S LIM. Ed. "Orange", BOXSTER S "RS 60 SPYDER", BOXSTER S "Sport Edition", BOXSTER SPYDER, BOXSTER S "PORSCHE Design Edition 2") >> Installing Starter

Installing Starter

  1. Install the starter.
    1. 1.1. Insert the starter and place it in installation position.
    2. 1.2. Tighten fastening screws -3-  using an extra-long extension -2-  . → Tightening torque: 45 Nm (33 ftlb.) 
    3. 1.3. Remove adhesive tape -1-  from the seam of the engine compartment cut-out.
    Fig 1: Installing Starter Fastening Screws Using Extra-Long Extension
    G09586417Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Connect electric plug connection on the solenoid switch.
    1. 2.1. Connect terminal 30 line and secure it with the fastening nut -3-  . → Tightening torque: 18 Nm (13 ftlb.) 
    2. 2.2. Connect terminal 50 line and secure it with the fastening nut -2-  . → Tightening torque: 6.5 Nm (5 ftlb.) 
    3. 2.3. Fit the cover -1- (-arrow-). 
    Fig 2: Connecting Electric Plug Connection On Solenoid Switch
    G09586418Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals