LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> Boxster Spyder, Automatic DCT >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 13 - Engine - CRANKGEAR, Pistons -- 987-BOXSTER-CAYMAN >> WM 136019 Removing And Installing Flywheel >> Installing Dual-Mass Flywheel >> Installing Double-Mass Flywheel

Installing Double-Mass Flywheel

Information 

Before re-installing the flywheel, clean the friction surface of the flywheel using a clean, lint-free cloth soaked in acetone or solvent naphtha).

  1. Position double-mass flywheel on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all fastening screws (8).
  2. Align toothed segment 9538/1  and tighten fastening screw again.
  3. Screw in and tighten fastening screws in diagonally opposite sequence. → Initial tightening: 19 ftlb.  ; → Final tightening - torque angle: 120° 
  4. Remove toothed segment.
scientia non olet · About LEMON Manuals