Technical Values
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Flywheel to crankshaft | M10 x 29 - always replace screws | Initial tightening | 25 Nm (19 ftlb.) | ||
| Flywheel to crankshaft | M10 x 29 | Final tightening - torque angle | 120° | ||
| Clutch pressure plate to flywheel | M8 - always replace screw | Initial tightening | 15 Nm (11 ftlb.) | ||
| Clutch pressure plate to flywheel | M8 | Final tightening - torque angle | 45° |