Preparing Hood Frame And Hood Covering

Fig 1: Identifying Installation Position Of Hood Covering

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information 

• Always replace the spare parts contained in the "convertible-top covering" scope of parts. 

1. All pins and screw joints must be checked for tightness before the hood covering is installed. → 613055 REPLACING HOOD FRAME 
2. Measure the Centre between the restraining straps and mark it on the tension bow.
3. Replace the tension strap. → 613055 REPLACING HOOD FRAME 
4. Pull clamping rail -3-  into the pull strip -1-  of the hood covering -2-  in direction of arrow.
5. Slide calmping rail -3-  through to the inside. Position fastening screw -4-  on hood covering -2-  and screw in by hand by approx. 4 turns.
   Fig 2: Identifying Clamping Rail, Strip Hood Covering

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Pull slide -1-  into the pull strip -2-  of the hood covering in direction of arrow.
   Fig 3: Pulling Strip Of Hood Covering

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.