Installing Convertible Top

→ Only install the hood in the vehicle together with the roll-over bar.

→ A second person is required during removal/installation.

Information 

• To position the convertible top frame with respect to the convertible top supports, the two convertible top supports must be pulled out by approx. 10 mm at the bottom. 
• This is the only way to install it on the roll-over bar. 

1. Pull the convertible top supports (left and right side) out by approx. 10 mm at the bottom
2. Place the complete convertible top frame -1-  with the two convertible top supports -2-  from behind -arrows A-  on the roll-over bar -3-  and position it correctly.
3. Position convertible top support -2-  on the roll-over bar -arrow B-  and screw down with the three fastening screws -4-  . → Tightening torque: 23 Nm (17 ftlb.) 
Fig 1: Installing Convertible Top Frame
Courtesy of PORSCHE CARS NORTH AMERICA, INC.