Subsequent Work For Body Repairs

→ Press on joint immediately after applying adhesive. Otherwise the adhesive bead must be removed and pre-treatment of the surface and application of the adhesive must be repeated.

→ Do not apply pressure to bonded parts until hardening is complete.

1. Removing vehicle from alignment bench
2. Cleaning spot-welded joints and sheetmetal flanges with a wire brush
3. Priming flange areas with 2K primer
4. Restore standard seal with body sealant → WM 5X00IN SEAM SEALS (ALL MODELS)
5. Restore standard underbody protection with underbody sealant → WM 5X00IN UNDERBODY PROTECTION (ALL MODELS)
6. Painting repair area and adjacent surfaces, if necessary
7. Installing removed accessories in the repair area
8. Apply cavity preservation.