Re-Imprinting New Vehicle Identification Number

Information 

• Only imprint vehicle identification number in a cathodic-dip coated sheetmetal part.  ¹⁾ 
• The area should be countered when imprinting the vehicle identification number. 

1. Stamp the vehicle identification number to be replaced using set of 8-mm letter/digit embossing tools with DIN 1451 closely spaced lettering Nr.128-1  and the Porsche star handheld punch 96930  in the space provided for this purpose.
2. Mask imprinted vehicle identification number.
3. Apply exterior paintwork.
4. Remove the vehicle identification number mark.
5. Paint repair area with clear lacquer.

   ¹⁾Cathodic-dip coating is the primer applied to the sheetmetal parts at the factory