| Carrier side section to body (front and rear), M10 x 1.5 x 80 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Cross member to carrier side section (top and bottom), M10 x 1.5 x 45 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Transmission bracket to Tiptronic transmission, M10 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Transmission bracket to manual transmission, M10 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Hydraulic mount to rear-axle carrier side section, M8 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
33 Nm (24 ftlb.) |
|
|
| Support plate to cross member, M10 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Support plate to V-brace (rear transverse strut) collar nut M10 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Diagonal brace with support plate to carrier side section (collar nut), M10 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Diagonal brace to body, M10 x 1.5 (changed to M12 x 1.5 in current model year 2008) |
Please note: This was changed to M12 x 1.5 in the current model year 2008! Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
M10=65 Nm (48 ftlb.) |
|
|
| Diagonal brace to body, M12 x 1.5 (M12 x 1.5 used instead of M10 x 1.5 in current model year 2008) |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
M12=110 Nm (81.5 ftlb.) |
|
|
| Control arm (lower control arm) to carrier side section (camber eccentric), M12 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
100 Nm (74 ftlb.) |
|
|
| Control arm 2 (toe control arm) to cross member (toe eccentric), M12 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
100 Nm (74 ftlb.) |
|
|