| Control arm 2 (toe control arm) and wishbone (lower control arm) to wheel carrier, M12 x 1.5 |
In conjunction with commercially available insert |
Tightening torque |
75 Nm (56 ftlb.) |
|
|
| Control arm 2 (toe control arm) and wishbone (lower control arm) to wheel carrier, M12 x 1.5/tightening torque of 55 Nm (41 ftlb.) is used only for insert 9558 |
A different value must be set on the torque wrench if insert 9558 is used! The nominal value 75 Nm (56 ftlb.) on the lock nut corresponds to a setting on the torque wrench of approx. 55 Nm (41 ftlb.). |
Tightening torque |
55 Nm (41 ftlb.) |
|
|
| Spring strut to wheel carrier, M12 x 1.5 |
|
Tightening torque |
110 Nm (81 ftlb.) |
|
|
| Suspension/stabilizer to wheel carrier, M10 |
Please note: Observe 3-step tightening procedure! |
3-step tightening procedure (Step 1: tighten to 50 Nm (37 ftlb.). Step 2: loosen by 90 degrees. Step 3: tighten to 65 Nm (48 ftlb.)). |
65 Nm (48 ftlb.) |
|
|
| Threaded connection for control arm 3 and control arm 4 (upper control arm) on wheel carrier, M12 x 1.5 |
|
Tightening torque |
110 Nm (81 ftlb.) |
|
|
| Brake cover plate and brake disc M6 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Brake calliper to front and rear axle, M12 x 1.5 |
Replace bolts on front and rear axle each time they are replaced. |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Brake hose bracket to rear-axle side section, M6 |
|
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Speed sensor to wheel carrier, M6 |
Tightening torque |
10 Nm (7.5. ftlb.) |
|
|
| Combination wire to wheel carrier, M6 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Threaded connection securing drive shaft to wheel hub, M22 x 1.5 |
Lightly grease the drive shaft toothing and the thread of the axle nut using Optimoly HT. |
Tightening torque |
460 Nm (340 ftlb.) |
|
|