WM 481019 Removing And Installing Steering Wheel (Except Turbo S Coupe "Ed. 918 SPYDER", CARRERA 4 GTS, Turbo S CABRIO "Ed. 918 SPYDER", CARRERA 4 GTS CABRIO, Gt3 RS 4.0): Installation

Information 

• The steering wheel is made of magnesium alloy. The tightening torques must be strictly observed. 
• Wheels straight ahead and observe the previously-applied markings. 
• Always replace multiple-tooth screw following removal (micro-encapsulated thread). 
• Observe specified tightening torque. → Tightening torque + torque angle: 30 Nm (22 ftlb.)+90° 
• Airbag unit must lock with an audible click! Check by pulling on the airbag unit. 

The steering wheel is installed in reverse order.