Removing Heating/Fresh Air Unit
Information
- Make sure not to damage the insulation of the main wiring harness.
- Immediately seal the openings of air-conditioning lines with suitable plugs.
- Unscrew fastening screw -1- for refrigerant line -C- and open the pressure line.
- Unscrew fastening screws -2- and remove expansion valve. → Removing expansion valve
- Unscrew the fastening nuts -6- for the heater/air-conditioning unit in the area of the plenum panel/firewall.
- Unscrew fastening screw -3- for securing holder of the heater/air-conditioning unit to right side of dashboard bracket (next to A-pillar).
- Unscrew fastening screw -4- for securing heater/air-conditioning unit to right side of dashboard bracket (passenger's side).
- Unscrew the two fastening screws -5- for dashboard bracket to right side of body.
- Unclip holder for electric harness with a screwdriver from right side of dashboard bracket.
- Now pull dashboard bracket a few centimetres forward on the right side.
- Pull out cotter pin -A- for holder of the heater/air-conditioning unit.
- Turn holder -B- for heater/air-conditioning unit by 90° and pull up and out.
- Lay down the air conditioner, release clamp for water drain hose -C- and pull off the water drain hose from the heater/air-conditioning unit.
- Carefully lift heater/air-conditioning unit forward with a screwdriver under the right side of the dashboard bracket.
- Release lower plug connection on heater/air-conditioning unit -a- and unplug.
- Release upper plug connection on heater/air-conditioning unit -a- and unplug.
- Cut tie-wraps of electric line (vehicle wire harness to heater/air-conditioning unit wire harness) with side cutters. Remove vehicle wire harness.
- Pull air conditioner forward on the right side, unscrew fastening screw -7- for B+ line holder and remove holder for heater/air-conditioning unit.
- Pull/push heater/air-conditioning unit as far as possible in direction of passenger's seat.
- Remove heater/air-conditioning unit from passenger compartment via passenger's door.