Remarks on measurement sheet

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

In order for measured results to be documented, however, a copy of the alignment card shown above can be used. In practice this means that alignment cards cannot be ordered!
The alignment cards can be used for all 911 Carrera (996) and the 911 GT3 (996)!

Prepare copies of the corresponding alignment card shown.
Before measurement (test 1 through test 3), enter the general data, vehicle type (for example 911 Carrera 4S) and the missing nominal values (new brake disc thickness / brake disc wear limit) into the copied alignment card.
NOTE: Actual values that are identical in all designs have already been entered!
Carry out measurements (actual status) and enter the values in the alignment card.
If brake discs are to be replaced, carry out Test 2, with the new discs again and enter the current values in a new alignment card.