Subsequent Work

→ 244619 REMOVING AND INSTALLING INTAKE-AIR DISTRIBUTOR - TURBO - section on "Installing"

→ Secure components to prevent them from falling down.

1. 2.1. Support the engine at the oil pan using the Hydraulic Jack HH2 WE 1033  and transmission jack plate of Transmission Jack VAG 1383 A WE 1082  .
2. 2.2. Alternative To Transmission Jack Plate: 

   Screw on the Mounting Peg 9163/2  in the middle using a wooden board (40 x 30 cm) and use it as a support.

   Fig 1: Identifying Transmission Jack Plate Mounting Peg

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. 2.3. Slowly lift the engine with the hydraulic jack.
   Fig 2: Identifying Engine Carrier To Engine Mounting (Cylinder Bank 4-6)

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. 2.4. Tighten two special M12 nuts (internal Torx, screw insert T55) -1-  on the engine mounting (hydraulic mount) at the left and right.

   → Tightening Torque: 85 Nm (63 ft. lb.) 

→ 263519 REMOVING AND INSTALLING TAILPIPE COVER - section on "Installing"

→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING - TURBO - section on "Installing"